Commissioning of color steel roll forming machine

- May 12, 2020-

Commissioning of color steel roll forming machine

1. First, the four corners of the front and rear lines of the color steel equipment are lined up from the large frame to the upper end of the bottom shaft, and then from the row to the back row, find a straight line and check whether the lower shaft is in a straight line. Up, level the left and right sides of the lower shaft horizontally.

2. Find the color steel equipment row and the back row, then fasten the lock nuts on both sides, pull a straight line in front of and behind the middle wheel, adjust the gap between the upper and lower shafts, and then follow the straight line Adjust the machine.

3. The debugging method for the deviation of the pressure plate of the color steel equipment, such as the plate runs to the right, pads the left corner (feeding frame), or falls on the right bottom (the number of axes runs off the bottom of the number of axes, the upper axis falls with the bottom axis.