Roof Machine Debugging

- May 16, 2019-

roof machine debugging


1. First, the heights of the four corners of the front and rear queues of the color steel tile pressing machine are the same from the upper end of the big frame to the upper end, and then from the first row to the last row, find a line straightened, check it, under Whether the axis is in a straight line, and the left and right sides of the lower axis are leveled.

2. Find the center of the first row and the last row of the color steel tile machine, then tighten the locks on both sides, and pull a straight line in front of and behind the center of the middle wheel to adjust the gap between the upper and lower shafts. After that, you can adjust the machine along the line.

3, color steel tile machine equipment - pressure tile machine plate deviation detection method, such as the plate to the right, pad left corner (feed frame), or the right side of the bottom flat (the first few axes run off the first few axes flat The upper shaft falls with the bottom shaft.


Roof Machine