Press brake and shearing machine adopt steel welded structure, standard upper and lower molds, vibration to eliminate internal stress, hydraulic transmission system, emergency stop of pedals, high strength and good rigidity.
Hydraulic roof sheet bending machine parameters
Cutting &Hydraulic type
Double guide pillar
Hydraulic motor power
380V/3phase/50 HZ(or as your requirement)
Decelerating motor+ Chain drive gear all by high-frequency
300mm/350mm H-Beam or 350mm
Cr12 mould steel heat-treated hardness of HRC = 60-62 degrees
A3 35mm thick plate arch
1. Machine is covered by plastic film.
2. PLC control box, spare parts and other small parts are packed by wooden carton box.
a. 18 months guarantee for the whole machine.
b. 24 hours technical support by email or calling
c. If there is any problem found of the machine, we will repair it for free in one year.