Trapezoidal roofing machine parameters
Main motor power
4kW/5.5KW/7.5KW or as actual demands
Hydraulic motor power
3kW/4KW.5.5KW or as actual demands
10-12MPa according to oil pump and pump motor
380V/ 3 phase/ 50 Hz (or as your requirements)
Automatic PLC control system
350H beams/400H beams according to machine demands
Wall sheet thickness
16mm/18mm/20mm/22mm according to machine demands
1 inch/1.2inch according machine demands
Galvanized steel coil/color steel coil/aluminum steel coil
0 - 25m/min (according to machine specification)
Common 11rolls or 25rolls (according to different design)
70mm/75mm/80mm (depends on different design)
Different parts of the trapezoidal roofing machine
Decoiler: common machine with 5 tons manual decoiler or you also can choose electric decoiler or hydraulic decoiler.
PLC control console:
Cutting parts: common is hydraulic pump drive cutting or you can choose electric motor drive cutting as follows:
Roll forming parts and Output table:
1. Our machine motor are GERMAN BRAND SEMENS;
2. Our roller spacer are 4mm thick seamless steel pipe;
3. Our output table can be adjust height according customer demands;
4. Our PLC control console can be look around 360degree;
5. All easy-broken pars can be change within 14month in free.
Other relative roof roll forming machine
Our company other products
Relative raw material
1. Main machine is covered by plastic film.
2. PLC control box, spare parts and other small parts are packed by wooden carton box.
1.we provide the technical support for whole life of our roof roll forming machines.
2.If buyers need the technician to go abroad, we will arrange the technician, but the buyers should take all the cost, including visa, round trip ticket etc.