Trapezoidal sheet roof wall panel machine parameters
Main motor power
4/5.5/7.5KW or as actual demands
Hydraulic motor power
3/4/5.5KW or as actual demands
10-12MPa according to oil pump and pump motor
380V/ 3 phase/ 50 Hz (or as your requirements)
Automatic PLC control system
350/400H beams according to machine demands
Wall sheet thickness
16/18/20/22mm according to machine demands
1 inch/1.2inch according to machine demands
Galvanized steel coil/color steel coil/aluminum steel coil
0 - 25m/min (according to machine specification)
Common 11rolls or 25rolls (according to different design)
70/75/80mm (depends on different design)
Details of the trapezoidal sheet roof wall panel machine
Detail display of the steel roof roll forming machine parts
01. Mainframe: GB H steel, hard texture.
02. Operator station: 360-degree rotation display.
03. Cutter: The main material is Cr12, which has high hardness.
04. Retaining pad: Prevent the nut from loosening.
05. Easy hanging: Prevent the machine from scratching during the movement.
06. Wheel: generally 45# steel, good hardness.
07. Travel switch: Limit the position or travel of the machine.
08. Rear hand knife: cut in advance to prevent waste.
09. Resin wheel: used to record the length of discharge and record data is more accurate.
10. Electric control cabinet: The main brands are Panasonic / Siemens / Schneider / Delta PLC.
1. Our roof tile Making Machine (except wearing parts) comes with 24 months warranty. Within the 24months period, for any parts damaged due to quality problems, we offer the replacement parts to the client free of charge.
2. We offer technical support for the entire life of our machines.
3. We can send our technicians to install and train the workers in the clients' factories.